GCS 로고

PLAXPOT does not induce ionized gases in the air to conduct heat but concentrates heat only in the problematic area,
applying energy to generate plasma. Hence, it does not affect the deep skin layers, yet contracts skin tissues and dramatically
reduces potential and continuous skin damage, while the ions generated from the plasma stimulate the dermis to produce collagen,
resulting in skin regeneration and reduction of skin pigmentation.

PLAXPOT’s Arc Plasma is an innovative treatment method that eradicates excessive tissues of the skin, which is the cause of wrinkles and drooping skin, through skin tightening.
An arc plasma of a minus pole is generated at the end of the tip about 1mm away from the skin surface, and the skin surface is sublimated into a nanometer-sized dot shape.
With the plasma sublimation process, the generated spots reduce the surrounding skin to the smallest size, and if one uses the Reduction Grid method where many spots are applied together, compared to other devices which use heat, wider and thinner treatment traces remain, while the skin tissues are contracted.
With this effect, one does not need to depend on excessive heat, and with a non-invasive method, drooping skin tissues are sublimated.

Existing plasma devices directly apply high-voltage to the narrow and deep, invasive areas of the skin, raising the possibility of burns and scars, and during treatment, it is difficult to apply the same amount energy of plasma, so the skin treatment is not even.
PLAXPOT can output plasma by insulating a high voltage through a dielectric, and it can obtain a power proportional to the electrode area by controlling the generated area of the electrode rather than controlling the voltage value itself, thereby providing uniform and safe procedures.

Common high-voltage discharge type (Other company’s products)

• Through the high-voltage generation part, the generated high-voltage is sent directly to the skin
• Energy is sent to a narrow and deep area, so that after treatment, there are risks of pigmentation and burns
• The area of application is quite restricted because only continuous output in the continuous mode is possible

PLAXPOT’s plasma types

• High voltage is not directly sent to the skin through high-voltage generation part, but through a dielectric material, the high-voltage is insulated, and plasma generated, and plasma is collected before being sent to the skin
• The sent area is relatively large, and not deep so that even delivery is possible to reduce the possibility of pigmentation and burns
• A separate pulse-control is installed in the device so that different pulse modes can be generated, and because the energy delivery method can be set up in various formats, the device can replace CO2 laser equipment

RF common electric-discharge method

• The area of application is small and the insertion is deep
• The even treatment effect is hard to predict according to treated spot
• There are risks of burns
• There is high chance of scars remaining

The plasma method

• Compared to the common electric-discharge method, the skin surface applied is even
• There is little risk of burns
• The sublimation effect required of soft surgery is sufficiently carried out